1/23/2019 1 Comment Pinnacle 710 Usb Driver For MacIn most cases when a USB Capture device does not work with Studio it is due to one of the following reasons: • Studio does not have the Pinnacle device selected as the Capture Source. • Studio does not have the correct port selected, either Composite or S-Video. • The video device (camcorder, VCR, etc) is not playing video when the capture is started. Please confirm, you have checked those setting in Studio. If you have and it still does not work, follow the steps below. This document will assist in installing the hardware and selecting the Pinnacle device in Studio. This troubleshooting guide will help you troubleshoot all Pinnacle USB capture hardware installations that are compatible with Studio. It will cover the software and hardware installation of the: Pinnacle • 700-USB • 500-USB • 710-USB • 510-USB Dazzle • DVC 170 • DVC 130 • DVC 100 • DVC 90 Most of these devices install in the same way, any differences will be noted. In the images below, the Dazzle DVC 100 is used as an example of how the device is displayed in Windows and in Studio. Your hardware will be displayed with its hardware name. Lacie porsche design desktop drive for mac 4tb. (Note: Some devices like the MovieBox, uses the same hardware as older packages and may show in the device manager with another name like 710 USB) To begin, check to see if the device is loaded and detected by Windows by following these steps. Is Studio installed? Have you installed Studio 14/15? All the drivers for the supported hardware install automatically when you install the Studio software. The Driver Update Tool – is a utility that contains more than 27 million official drivers for all hardware, including pinnacle 710-usb driver. Hardware drivers for Pinnacle / Dazzle* Studio video devices Note: The files contained in this package are hardware drivers only. Beside the driver, a compatible version of Studio is required. If Studio is not installed, please do so now. Please disconnect any Pinnacle USB capture device before you install Studio. USB PORT: Now that you have Studio installed, connect the USB device up to the proper type of USB port on the system. (NOTE: Some of our devices only work with USB 2.0 ports and you need to connect these devices to a USB 2.0 port, not a USB 1 port) Windows should find and load the drivers. If it does not, the Add New Hardware Wizard may ask you to browse to their location. Pinnacle 500 Usb Driver DownloadPinnacle 710 Usb ManualBrowse to the location on the hard drive you installed Studio to, which is typically your C: drive. Typically, C:Programfiles Pinnacle/Studio14. Once Windows has found drivers for the device, check in Device Manager to see if the driver has been loaded properly using the following steps: • Click on Start - Control Panel • Double-click on System • Click on the Hardware tab • Click on the Device Manager button • Click on the '+' symbol (plus sign) to the left of the heading Sound, Video and Game Controllers • If the device is listed properly under the Sound video and game controller section, it will look like the picture below. The DVC 100 is listed below as an example. In your case, the Pinnacle device you installed must be listed similarly but with it's device name. If it is, move on to Step C, otherwise continue with Step below. NOTE: You can also get to Device Manager by right clicking on My Computer, then clicking on the Hardware tab and then the Device Manager button.
1 Comment
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |